7 IBU Prototype-Part 4

We went there early in the morning to que up for polypipe curving but we still have to wait half hour for our turn!


Start to become not patient when waiting,he..

After curving the polypipe,we polish the polypipe before heat it.

Then,we cut the edge of the polypipe so that it become not very sharp.

Start to heat the polypipe using gas.Then,we press the both side of polypipe using the clamp so that the head side of polypipe become flat.

Become flat after pressing.

We labelled the cross 3.6cm from the top of polypipe to make a small hole on it using machine.

The product:

In the next morning,we continue our work again!!

Due to mistake,we measure the length of bamboo from the hole of the polypipe from end to end to makesure that it was in right length which was 2.284m.The mistake was we measure only the length of bamboo without considering the polypipe.

So,we shorten the length of the bamboo by cutting it.Thanks for Faris,Azwan and Safwan for helping us(girls)to cut the bamboo.

Then,we thin the bamboo again using parang and hammer.

Place the polypipe at the end of bamboo using hammer.

We found that the the bamboo was crack inside after we hammer it.So i tried to paste some pieces of bamboo on the cracking part using the glue borrow from bengkel as told by En.Rusli in the morning.

Paste bamboo pieces inside the cracking part.

We had done and this was the final product of my bamboo struts.